Ready-welded NX corners join profile sections without on-site corner fitting. The factory junction preserves geometry and shortens installation.
With manual assembly, profiles are cut and joined on site. On a visible contour, any cutting error leaves a step or gap. A welded corner arrives finished: connect it to straight sections and tension the membrane according to the system instructions.
The corner must match the profile series and model. The catalogue includes turns, intersections and junctions at specified angles. Check type, dimensions and finish on the NX page, not by appearance alone.
Order corners with the profile for the same project. This makes quantity, colour and compatibility easier to verify. See their use in light lines in LIGHTRA.
Frequently asked questions
Can a corner be welded on site? Yes, with suitable equipment and experience. A factory corner reduces dependence on manual fitting.
Does one corner fit every series? No. Section and seating must match the straight profile sections.